FireBeetle Covers-Proto Board Doubler

The DFRobot FireBeetle series is a low - power micro - controller designed specifically for the Internet of Things (IoT). It focuses on low - power IoT nodes, enabling you to quickly and conveniently build IoT hardware platforms. There are three types in the FireBeetle series: main control boards, expansion boards (Covers), and related accessories. The Proto Board Doubler is a great addition to the FireBeetle series. It has 14x7x2 general 2.54mm solder holes with standard spacing. The two prototyping boards connect to one master board, sharing common VCC, 3.3V, and GND soldering pads. This makes it perfect for soldering any electronic component. Also, its compatibility with other FireBeetle projects makes it the top choice for overlay circuit prototypes. Features include plug - and - play compatibility with DFRobot FireBeetle Series products, cost - effectiveness, and a small size for easy installation. Documents available are schematic and layout. The shipping list includes one FireBeetle Covers - Proto Board Doubler, four 18 - pin 2.54mm pins, and four 18 - pin 2.54mm long pin headers.

Using the FireBeetle Covers - Proto Board Doubler is a breeze. First, connect the two prototyping boards to your FireBeetle master board by soldering them to the common VCC, 3.3V, and GND soldering pads. Once connected, you can start soldering your electronic components onto the 2.54mm solder holes. It's compatible with other FireBeetle products, so you can easily integrate it into your existing projects. When handling the board, be careful not to apply too much pressure as it's relatively small and delicate. Store it in a dry and clean place to avoid damage. If you need to clean it, use a soft, dry cloth. That's all there is to it, and you're ready to start building amazing IoT projects!