Pimoroni OmniVESA

The Pimoroni OmniVESA is an outstanding mounting solution for your Raspberry Pi. It's super easy to use! Just take off the protective backing from the OmniVESA and follow Pimoroni's instructions. You can mount your Raspberry Pi either bare or in any Pimoroni case, and some other cases are also supported. The nylon screws included are long enough for all relevant cases. If they stick out too far from your chosen case, you can easily trim them with pliers. Remember to wear eye protection when cutting. This OmniVESA supports 75mm and 100mm spacing mounts. The kit comes with 1x OmniVESA, 2x M4 16mm Nylon Knurled Thumbscrews, 2x 5mm Nylon Spacers, 2x M2.5 x 16 Nylon Screws, and 3x M2.5 Nuts. It's compatible with all Raspberry Pi models and all Pimoroni Pibow cases.

Using the Pimoroni OmniVESA is a breeze. First, remove the protective backing from the OmniVESA. Then, follow Pimoroni's instructions to mount your Raspberry Pi. You can choose to mount it bare or put it in a Pimoroni case or some other supported cases. When using the nylon screws, note that they're long enough for all relevant cases. If they stick out too far from your case, you can use pliers to trim them down. But don't forget to wear eye - protection when cutting. As for maintenance, keep the OmniVESA and its parts clean and dry. If you're not using it for a long time, store it in a cool and dry place.