FireBeetle Covers Prototype Board

The DFRobot FireBeetle series is a low - power micro - controller crafted for the Internet of Things (IoT). It's all about quickly and conveniently building an IoT hardware platform, targeting low - power IoT nodes. There are three types in the series: main control boards, expansion boards (Covers), and related accessories. This Prototype Board is fully compatible with the FireBeetle series products. It features 14x7 general 2.54mm solder holes with standard spacing. You can easily connect it to the master board via VCC, 3.3V, and GND soldering pads. It's a cost - effective, small - sized board that's a breeze to install. With these features, it's perfect for soldering any electronic component and creating overlay circuit prototypes. **Features** - Compatible with DFRobot FireBeetle Series, plug - and - play - Cost - effective - Small size for easy installation **Specifications** - 14x7 general 2.54mm soldering pads - Dimension: 29.00x58.00mm/ 1.41x2.28 inches - Weight: 18 g **Documents** - Schematic Layout **Shipping List** - FireBeetle Covers - Proto Board x1 - 18 pin - 2.54mm pin x4 - 18 pin - 2.54mm long pin header x4

Using the FireBeetle Prototype Expansion Board is easy. First, connect it to the master board by soldering the VCC, 3.3V, and GND soldering pads. Then, you can start soldering your electronic components onto the 2.54mm solder holes. This board is plug - and - play, so you don't need to worry about complex setup. When handling the board, be gentle as it's small and light. Avoid bending it too much to prevent damage to the solder holes. For maintenance, keep it in a dry and clean place. If it gets dirty, you can use a soft, dry cloth to wipe it. With this board, you can quickly create overlay circuit prototypes for your IoT projects.