Pogo Pin Probe Clip - 6 Pins with 2.54mm / 0.1 Pitch

The 6-pin Pogo Pin Probe Clip with a 2.54mm/0.1 pitch spacing is an excellent tool for testing and connecting with high precision, no soldering needed! It's like an alligator clip but comes with an array of built-in springy pogo pins. You can easily connect it to a PCB with classic 0.1-spaced pad holes without soldering or using a special adapter cable. The clip is made of PCB sections and a sandwich structure to support the thin pogo pins. The pogos extend up into a 1x6 0.1 header, allowing everyday socket header cables to plug in. Use these cables to connect to your programmer or adapter.

Using this Pogo Pin Probe Clip is easy. First, make sure your PCB has the classic 0.1-spaced pad holes. Then, place the clip on the PCB pads. The springy pogo pins will make good contact. Next, plug an everyday socket header cable into the 1x6 0.1 header on the clip. You can then connect this cable to your programmer or adapter for testing. When using, avoid applying too much pressure on the clip as it may damage the pogo pins. Also, keep it away from moisture and dust. To maintain it, clean the pogo pins gently with a soft brush every once in a while to keep them in good condition.