Micro SD Card Extender - 68cm (26 inch) long flex cable

Tired of struggling with SD card sockets at the back of your new gadget? Try our Micro SD Card Extender! It features a long, flexible cable with a pseudo Micro SD card on one end and a matching socket on the other. Simply plug in the card part and place the socket wherever you need. This extender is perfect for 3D printers, single - board computers, and data - logging kits, solving length - constraint issues. It also helps protect your SD card from wear and tear. The sockets use a push - push mechanism. Insert the card to lock it and press again to release. There's a small pictogram on the socket to show the correct orientation. We've tested it with a Replicator 3D printer (using an adapter), various Feathers, and a Raspberry Pi 3 Linux computer, and it works fast and error - free. However, keep in mind that it's a workaround, so high - speed and high - noise environments might cause problems. Note: Micro SD Card is not included.

Using the Micro SD Card Extender is easy. First, plug the pseudo Micro SD card part of the extender into your device's SD card slot. Then, place the other end, the matching socket, wherever you find it convenient. When inserting your Micro SD card into the socket, just push it in until it locks. To remove it, press the card again. There's a little pictogram on the socket to show you the right way to insert the card. Be aware that while this extender works well in many cases, high - speed and high - noise environments may lead to issues. As for maintenance, keep the cable and sockets clean and free from dust. Avoid bending the cable too sharply to prevent damage. And remember, the Micro SD card itself is not included with the extender.