Metal Gear Servo 180 Degrees

The High-Torque MG996R Digital Servo is a powerhouse in a small package. With metal gearing, it offers an extra-high 10kg stalling torque. It's an upgraded version of the well - known MG995 servo, featuring improved shock - proofing and a redesigned PCB and IC control system for greater accuracy. The gearing and motor are also enhanced to improve dead bandwidth and centering. It comes with a 30cm wire and a 3 - pin 'S' type female header connector that fits most receivers like Futaba, JR, GWS, etc. Control System: Pulse Width Control. Working Frequence: 20ms period / 50hz (Analog Control). (RX) Required Pulse: 3.0 ~ 5 Volt Peak to Peak Square Wave. Operating Voltage: 4.8 ~ 6 V DC Volts. Operating Temperature Range: 0 to + 55 Degree C. Operating Speed (4.8v): 0.200 sec/60° degrees at no load. Operating Speed (6v): 0.160 sec/60° degrees at no load. Stall Torque (4.8v): 9.4kg/cm. Stall Torque (6v): 11kg/cm. Potentiometer Drive: Direct Drive.

Using this MG996R servo is easy. First, connect the 3 - pin 'S' type female header connector to your receiver. Make sure your power source is within the 4.8 - 6V DC voltage range. When installing, handle it gently as it has precision parts. Don't expose it to temperatures outside the 0 to + 55 Degree C range, as it may affect performance. For maintenance, keep it clean and free from dust. Check the wire regularly for any signs of damage. If you notice any issues with its movement or accuracy, you might need to check the control system settings. Enjoy using your servo!