This 3-pin JST connector comes with red, black, and yellow wires, each 5 inches long. Fully assembled as shown, it directly connects to a variety of Sharp sensors. It's a quick and easy solution that can save you 15 - 20 minutes compared to making your own wiring harness. If you need this cable along with the mating connector, check out the wire assembly in the related products below!
Using this 3 - pin JST infrared sensor jumper cable is super easy. First, identify the red, black, and yellow wires. Then, connect it directly to your Sharp sensor. It's already fully assembled, so you don't have to waste time making your own wiring. When using it, make sure the connection is firm to avoid signal interruptions. As for maintenance, keep it away from water and sharp objects. If it gets dirty, you can use a dry cloth to gently wipe it. Don't try to disassemble it on your own, as it's pre - assembled for your convenience.
