DiMeCard 8 microSD Card Holder

Mary Poppins had her magical carpet bag, and 90s kids had their Pokémon card binders. Now, we have the amazing DiMeCard, a super-slim 8-piece microSD storage card holder. It's a must - have you never realized you needed! If you work with single - board computers like the Raspberry Pi or BeagleBone, or do a lot of datalogging or photography, you know microSD cards can quickly pile up. They're so tiny that it's hard to label what they're for. That's where DiMeCard shines. For IT or photography work on the move, it fits neatly into your purse or wallet. For daily use, you can just leave it on your desk, and it won't get lost. Our custom Adafruit memory card holder has a colorful Raspberry Pi GPIO pinout diagram on one side and 8 writable panels to note card contents on the other. Each card is held by an internal spring clip, giving you a satisfying click when inserted and locked. This protects the card's chip from bending. The lanyard hole has been tested at 100 RPM without any cards falling out. Note: Lanyard and microSD cards not included.

Using the DiMeCard is easy. Just insert your microSD cards into the slots, and you'll hear a click to know it's locked in place. You can write down what each card is for on the writable panels. For work on the go, slip it into your purse or wallet. When you're at your desk, leave it out - it's big enough not to get lost. Be careful when inserting and removing cards to avoid damaging the spring clips. Since the lanyard and microSD cards aren't included, you'll need to get those separately. There's no special maintenance needed, just keep it clean and dry.